Flat, washed-out roof colour
A change like this usually means the coating is losing its grip, and it is cheaper to act while the surface underneath is still sound.
Professional painting · Geelong
Roof Painting in Geelong — Prepared to Last
Roof coating quoted only after the roof is assessed from safe access. Tile or metal, we check the substrate and existing finish, then set out cleaning, primers, overspray control and anything a coating simply cannot fix.
Roof Painting right across Geelong
A coating can restore colour and shed water off a sound roof, but it will not repair one. We look at the material, the fixings and the state of the existing finish first, then say plainly whether coating is worth doing.
We travel to properties throughout Geelong's inland suburbs and out across the Bellarine and Surf Coast. The assessment weighs up preparation, access, the coating already on the surface and the finish you are after before any figure is put in writing.
What our roof painting service covers
Condition assessment from safe accessColour selection for tile or metalCleaning plan suited to the surfacePrimer and sealer recommendationsColorbond and zincalume coatingConcrete and terracotta tile coatingMasking and overspray controlGutter and downpipe protectionWritten exclusionsFinal inspection from ground and access
What sits outside the scope
Repairs and specialist trades beyond the agreed painting work are listed separately rather than buried inside a vague line item. You will know what is quoted and what is not.
Signs it may be time to repaint
Moss and lichen on shaded roof planes
A change like this usually means the coating is losing its grip, and it is cheaper to act while the surface underneath is still sound.
Chalk lifting off on your hand
A change like this usually means the coating is losing its grip, and it is cheaper to act while the surface underneath is still sound.
Rust bloom around screws and laps
A change like this usually means the coating is losing its grip, and it is cheaper to act while the surface underneath is still sound.
Mismatched patches from earlier repairs
A change like this usually means the coating is losing its grip, and it is cheaper to act while the surface underneath is still sound.
Our roof painting process
Inspect the roof from safe access
Each stage is checked against the written scope and against the weather and conditions on the day.
Confirm whether coating suits it
Each stage is checked against the written scope and against the weather and conditions on the day.
Issue a written scope
Each stage is checked against the written scope and against the weather and conditions on the day.
Clean, treat and prepare
Each stage is checked against the written scope and against the weather and conditions on the day.
Apply the specified system
Each stage is checked against the written scope and against the weather and conditions on the day.
Where the difference shows
A quick repaint versus a properly prepared roof painting
The week the job wraps up they look much the same. One winter and one hot summer later, they do not.
The quick repaint
- A quick hose-off or dry wipe
- Colour rolled over chalk and lifting edges
- Open joints and gaps left as they are
- One thin coat stretched to cover
- The same tin used on every wall
Salt and moisture stay trapped under the film, so peeling and mould usually return at the same spots.
The prepared repaint
- Full wash, mould treatment and rinse
- Failed coating scraped out and edges feathered
- Joints sealed before the winter rain
- Coats laid on at full film thickness
- Product chosen for the substrate and the aspect
The coating bonds to a sound, sealed surface, so the next maintenance visit is a wash and a touch-up rather than a strip-back.
Substrate-led approach01 02 03 04 05 06
Surfaces we coat and the preparation each one needs
Weatherboard and timber
Board ends, splits and soft spots get looked at first. Timber swells through winter and shrinks in summer heat, so flexible coatings and fully primed bare patches beat an extra topcoat.
Rendered walls
Fine cracks are opened up and filled with a flexible product, and fresh or patched render takes an alkali-resistant sealer so the colour above it stays stable.
Cement sheet cladding
Express joints, sheet ends and fixings are sealed properly. That detail is what keeps driving rain from tracking in behind the cladding.
Colorbond and metalwork
Rust is ground back and treated, then a metal primer goes on before any finish coat is even opened.
Brick and blockwork
Efflorescence is brushed off and porosity tested, because thirsty older Geelong brickwork can swallow a first coat without the right sealer under it.
Decks, rails and fences
Wash, sand back raised grain and replace boards that are past saving, then coat with something built for footfall, standing water and full afternoon sun.
What shapes a roof painting quote in Geelong
We do not publish a flat rate, because two houses on the same street can need very different work. The scope is written after we have walked the property and seen the condition, the access and the substrate for ourselves.
Surface condition
Assessed during the on-site visit and written into the quote you receive.
Access and height
Assessed during the on-site visit and written into the quote you receive.
Preparation needed
Assessed during the on-site visit and written into the quote you receive.
Coating system
Assessed during the on-site visit and written into the quote you receive.
Colours and detail work
Assessed during the on-site visit and written into the quote you receive.
Total area to coat
Assessed during the on-site visit and written into the quote you receive.
Roof Painting across Geelong and the coast
We come out to properties in Newtown, Belmont, Highton, Grovedale, Waurn Ponds, Bell Park, Corio, Ocean Grove, Torquay, Barwon Heads and the streets around them. Choose your suburb for detail on local housing and exposure.
Helpful roof painting guides
What Shapes a House Painting Quote in Geelong
How preparation, access, substrate and scope decisions come together in a written painting quote.
Read the guideSeasonal Paint Maintenance Checklist for Geelong Homes
What to check after a wet Victorian winter and again before summer heat arrives.
Read the guideChoosing Exterior Paint for Salt Air on the Bellarine
How coastal exposure changes washing, priming and coating decisions on the Surf Coast.
Read the guidePractical answers
Frequently asked questions
Can any roof be coated, or do some roofs need replacing instead?
+
Most sound roofs with isolated rust, fading or moss can be restored through coating, but roofs with widespread structural corrosion, extensive cracked tiles or repeated multi-point leaks are usually better addressed with targeted repair or replacement rather than coating over the problem.
Do you work on both metal and tile roofs?
+
Yes, we coat Colorbond and zincalume metal roofs as well as cement and terracotta tile roofs, using preparation and coating systems suited to each substrate.
How do you deal with rust on a metal roof before painting?
+
Corroded areas are ground or wire-brushed back to sound metal, treated with a rust converter or inhibitor, and spot-primed before the topcoat system is applied.
Will you fix cracked tiles or failing ridge pointing as part of the job?
+
Yes, cracked or slipped tiles and deteriorated ridge pointing are identified during inspection and addressed before coating, since painting over these issues won't stop leaks.
What is a heat-reflective roof coating?
+
It's a topcoat formulated to reflect more solar radiation than a standard finish, which can reduce roof surface temperature and help with internal heat load, particularly on north and west-facing roof planes.
Do you protect solar panels and gutters during the work?
+
Yes, solar panels, gutters, downpipes and skylights are masked and protected before cleaning and coating begins, and panels are worked around rather than walked on.
How long does a roof coating job usually take?
+
It depends on roof size, pitch and the amount of preparation and repair required, and it can also be affected by weather, since cleaning and spraying both need dry, settled conditions.
Do you service roofs across all Geelong suburbs?
+
Yes, we carry out roof inspections and coating work across Newtown, Belmont, Highton, Grovedale, Waurn Ponds, Bell Park, Corio and the Bellarine and Surf Coast towns.
Can I choose any colour for my roof coating?
+
Generally yes, though we'll advise on how a colour performs for heat reflectivity and how it fits any body corporate or estate requirements that may apply to your property.
How do I get a roof painting quote?
+
Call for a free quote or send the quote form on this page with some photos of your roof, and we can arrange an inspection to scope the work accurately.
Prefer to talk it through?
Call our Geelong painting team during business hours and describe the property. We will arrange an on-site assessment and a written quote.
Local mobile painting service
Planning roof painting in Geelong?
Speak to a Geelong painter about your project and book an on-site assessment.